14 November 2016

FWF: Spinner & Propeller. Spinner plate assembly.

The S-602-1 Spinner Plate and S-602B Doubler Ring are match drilled.


The center section of the Spinner Plate is removed via a combination of a multitude of holes made with a large unibit (left) and careful, though judicious, use of the Dremel (right), the latter of which was completed by my friend.  I attribute to "the 51% rule" that these parts aren't both pre-cut.




The parts are then primed with Napa 7220 and subsequently riveted together.


No comments:

Post a Comment