My roll servo was installed back in November 2013 and December 2013. However, only now was its wires finally routed and its bolts safety wired (the latter by my friend).
What isn't obvious in the picture is that the ground wire is attached via an eyelet contained in the bolt holding the Adel clamp. The square cutout in W-823-1 Aileron Bellcrank Bracket is for a Molex connector leading to the roll servo. I just caulked in edge grommets on it then fixed and routed the wires through there.
What isn't obvious in the picture is that the ground wire is attached via an eyelet contained in the bolt holding the Adel clamp. The square cutout in W-823-1 Aileron Bellcrank Bracket is for a Molex connector leading to the roll servo. I just caulked in edge grommets on it then fixed and routed the wires through there.
No comments:
Post a Comment